E46034 Flush Mounting Kit
for Ray48 & Ray54/E
5583-002 Flush Mount Assembly
Bracket Subassembly, qty 2
Gasket, 1 ea, Ray48 & Ray54/E
Screw, M6, qty 2, and
Lock Washer, M6, qty 2
RAY48
RAY54
1. Use template to cut out required opening in console.
2. Remove appropriate Gasket from pre-punched sheet
and place on radio, behind front fascia.
3. Insert unit into cutout in console.
4. Attach both Bracket Subassemblies to radio using M6
Screws and Lock Washers.
5. Tighten Bracket Subassembly mounting screws until
unit snugly attached to console.
Pre-punched gaskets sheet
172 mm (6.8") ALLOWANCE FOR FLUSH MOUNT KIT
135 mm (5.3") CUTOUT
8.5 mm (.33")
10 mm (.4")
Ray48 Mounting Template
51 mm (2")
CUTOUT
70 mm
(2.75")
CUT OUT SHADED AREA
9 mm (.4")
18.5 mm
(.73")
ALLOW 110 mm (4.3") FROM RADIO MOUNTING SURFACE FOR RADIO DEPTH.
190 mm (7.5") ALLOWANCE FOR FLUSH MOUNT KIT
150 mm (5.9") CUTOUT
8 mm (.3")
8 mm (.3")
61 mm
(2.4")
CUTOUT
Ray54/E Mounting Template
79 mm (3.1")
CUT OUT SHADED AREA
10 mm (.4")
167 mm (6.6")
20 mm
(.8")
3033-010
|